Bosch Kl 1208 Manual
Based on the model number KL 1208, you are likely looking for information on the Bosch AKE 30 S or a similar model in the Bosch "S" series electric chainsaws (the KL 1208 is typically the code for the power supply unit/transformer used with these saws).
Below is a condensed "helpful paper" version of the manual, covering the essential setup, safety, and operating instructions for the Bosch Chainsaw AKE 30 S. bosch kl 1208 manual
Parts & Accessories
- Replacement spools/line (specify correct diameter and length)
- Replacement guards and handles
- OEM replacement parts available from Bosch service centers or authorized dealers
A. Technical Specifications (From Page 2 of the Manual)
| Parameter | Value |
| --- | --- |
| Input Voltage | 110-120V AC (US) / 230V AC (EU models) |
| Output Voltage | 12V (nominal, for lead-acid) |
| Charging Current | 1.2 Amps (max) – hence the “1208” name |
| Battery Capacity | 2 Ah – 60 Ah |
| Protection Class | IP54 (splash-proof) |
| Operating Temp | -20°C to +50°C | Based on the model number KL 1208 ,
Note: Do not charge batteries larger than 60Ah. The manual explicitly warns that doing so may overload the internal transformer. Parts & Accessories
1. Technical Specifications
- Power: 1800 W
- Bar Length: 30 cm (12 inches)
- Chain Speed: 9 m/s
- Weight: Approx. 4.0 kg
- Oil Tank Capacity: 0.2 Liters
- Kickback Brake: Mechanical instant brake (activates in approx. 0.1 sec).
2. Safety Features (Read Carefully)
- Kickback Brake (Hand Guard): The plastic guard in front of the top handle acts as a brake. If the saw kicks back, your hand hits the guard, stopping the chain instantly.
- To Reset: Pull the guard back towards the handle until it clicks.
- Lock-Off Button: Prevents accidental starting. You must press the lock-off button before squeezing the trigger.
- Chain Catcher: Located at the bottom of the saw; catches the chain if it breaks or derails to prevent injury.
4.3 Connection Sequence (Off-vehicle)
- Attach RED (+) clamp to positive terminal.
- Attach BLACK (-) clamp to negative terminal.
- Then plug charger into mains.
