Corghi Exact 60 Manual Today

The Corghi EXACT 60 is a wheel aligner system that typically utilizes goniometers and inclinometers to measure critical vehicle alignment angles such as toe, camber, and caster. While specific digital copies of the EXACT 60 manual can be rare online, it belongs to the broader "EXACT" series of professional alignment equipment. Core Manual Topics & Procedures

Based on technical documentation for the EXACT series, the manual generally covers:

Measurement Basics: Using sensors and central units to track total toe, half toe, camber, caster, and kingpin angles. corghi exact 60 manual

Database Management: Navigating the vehicle databank (often requiring passwords like "databank") to select specific vehicle makes and models.

Runout Compensation (ROC): Procedures for compensation that may or may not require lifting the vehicle (Push Mode vs. Standard ROC). The Corghi EXACT 60 is a wheel aligner

Calibration: Ongoing sensor calibration checks to ensure the accuracy of the targets and heads.

Safety & Electrical: Requirements for proper grounding and the use of circuit breakers to prevent damage to sensitive electronic components. Where to Access Manuals The rotation is controlled by a flow control

If you are looking for a physical or digital copy, you can find resources through these official and specialized channels: EXACT 6000-60E 1.0 07 - 94 - e | PDF | Floppy Disk - Scribd

4.2 Turntable Rotation Speed

8. Calibration & Adjustment Guide

Problem: The rim does not center automatically. Fix: Adjust the clamp jaw synchronization.

  1. Remove the top cover.
  2. Locate the central gear ring.
  3. Loosen the 4 jaw locking bolts (5mm Allen).
  4. Manually center the jaws using the laser-etched center mark.
  5. Retighten bolts to 18 Nm.

Problem: The tire slips during rotation. Fix: Increase downforce on the assistant arm. If unavailable, adjust the "slipper clutch" on the table drive shaft (located under the rubber mat) to increase torque up to 20% above factory setting.

Step 2: Entering Dimensions (Manual Input)

The Exact 60 requires three specific measurements to calculate balance. These are usually input using the number pad:

  1. Distance (A): Measure the distance from the machine housing to the inner rim edge.
    • How to input: Press the distance button (often labeled A or a ruler icon), enter the number on the keypad (e.g., 45), and press Enter.
  2. Width (B): Measure the width of the rim using the caliper provided with the machine.
    • How to input: Press the width button (labeled B), enter the number, and press Enter.
  3. Diameter (C): Identify the rim diameter size (e.g., 14 inches).
    • How to input: Press the diameter button (labeled C), enter the number, and press Enter.