The programming software for the HYT TC-320 (often referred to as Customer Programming Software
) is an essential tool for customizing the radio's 16 channels, frequencies, and features like VOX or power levels. Essential Requirements Software Version : The most current verified version is Operating System : This software is generally only compatible with Windows PC ; Mac computers are not natively supported. Hytera PC30 programming cable
is required to connect the radio's Mini USB jack to your PC's USB port. Atlantic Radio Communications Corp. Step-by-Step Programming Guide Installation : Install both the TC-320 CPS and the dedicated USB cable driver on your computer before connecting the device. Connection PC30 cable into your computer and the Mini USB jack on the side of the radio. Turn the radio Reading Data Launch the software and select Programming -> Frequency Reading (or click the "Read from Radio" icon). The radio’s LED will glow during this process. Customizing Settings Frequencies
: Enter your desired transmit (TX) and receive (RX) frequencies within the 400-470 MHz Privacy Codes CTCSS/DCS tones to filter out unwanted interference. : Configure the Side Key (SK)
for functions like monitoring or scan via long or short presses. Writing to Radio Programming -> Write Frequency hyt tc-320 programming software
A prompt will appear confirming "Frequency writing is successful" once complete, and the radio will automatically restart. Manual Adjust Mode (Advanced)
If you need to adjust hardware-level parameters without software, you can enter Manual Adjust Mode by holding the PTT, Side Key, and Power buttons simultaneously until the LED glows RADIOSOFTWARE.ONLINE Where can I help you find a reliable download link or a compatible programming cable for your setup? Hytera TC320 Customer Programming Software & Firmware
The HYT TC-320 is a compact analog radio that requires specific Customer Programming Software (CPS)
and a compatible cable to customize its 16 channels and advanced features. Twowayradiocenter.com Required Equipment : The standard utility is the HT518-320-310 Programming Software The programming software for the HYT TC-320 (often
(e.g., v5.02 or newer). Note that this software is strictly for Windows PCs ; it is not natively compatible with Mac. : You will need the Hytera PC30 USB Programming Cable
. Some third-party ribless cables are also available on marketplaces like Step-by-Step Programming Guide Hytera TC320 Customer Programming Software & Firmware
This is a technical guide and research paper focused on the HYT TC-320 programming software. Since the TC-320 is a legacy professional two-way radio, this paper addresses the practical needs of technicians, radio enthusiasts, and small business owners who need to reprogram these devices.
Once your data is entered, click the "Write" button (arrow pointing from the computer to the radio). Step 6: Write to Radio Once your data
The TC-320 cable uses a counterfeit Prolific PL2303 chip in 90% of aftermarket cables. Prolific’s official drivers (v3.8.0 and later) actively block counterfeit chips.
Solution:
| Parameter | Typical Value | Note | |-----------|---------------|------| | Frequency (RX/TX) | e.g., 462.5625 (FRS ch1) | Must match all radios in fleet | | Squelch Level | 3 | 0=open, 9=very tight | | CTCSS (RX/TX) | 67.0 Hz | To block interference | | Bandwidth | 25 kHz (wide) | For compatibility with older analog | | TX Power | High (2W) | Low saves battery but short range |
Websites like RadioReference.com and Modem DK (a Dutch radio software archive) maintain legacy software libraries. Search for "TC-320 CPS" – the file is typically named TC-320_Setup.exe or HYT_TC-320_CPS_v1.05.zip. Always scan downloaded files with Windows Defender or Malwarebytes.